Vibramate Vibramate V5 Standard

49

Mount Kit for Bigsby B5

  • Installation requires no drilling
  • Colour: Chrome
  • Screws and felt pads included (Bigsby not included)
Tillgänglig sedan Januari 2012
Artikelnummer 276200
försäljningsenhet 1 Styck
1 055 kr
inklusive moms, 99 kr frakt tillkommer
i lager
i lager

Produkten finns i lager och kan levereras omgående.

Information om leveransen
Beräknat utskeppningsdatum till Tisdag, 30.04.
1

49 Kundbetyg

4.5 / 5

Du måste vara inloggad för att kunna betygsätta en produkt.

Obs! För att undvika att betygsättningen är byggt på rykten eller smygreklam kan bara kunder som har köpt produkten från oss sätta sitt betyg.

Efter inloggningen i kundcentret kan du se vilka produkter som kan betygsättas.

hantverkskvalitet

29 Recensioner

B
Bra uppfinning!
Brutuz 07.05.2020
Ska installera ett bigsby. Denna produkt gör att man slipper borra i gitarren och att man när som helst kan ta av svajanordningen.
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
j
Excellent bit of kit
jclift 23.05.2013
This is a very neat and solid way to mount a Bigsby on a guitar without drilling or modifying it. I installed it on a Gibson Les Paul, which took me only a few minutes, plus a re-string. I'm very pleased with the result - it keeps in tune, and plays very well. No sustain lost that I can tell. Highly recommended device
hantverkskvalitet
1
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
T
Vibramate - unbeatable for fast and non invasive Bigsby installation!
Tom2176 25.01.2014
The Vibramate literally takes minutes it install, leaves no holes or marks on your guitar and is a nicely engineered piece of kit.

Make sure you take the time to tighten the bolts which hold your Bigsby to the Vibramate carefully, because it's possible to pull the Bigsby out of whack, causing either the arm / string holder bearing or the string guide roller to bind and not move freely. Make sure both bearings have no friction before you string up, and if they do, tighten or loosen the screws holding the Bigsby to the Vibramate until they rotate freely.
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
A
The mount kit won't fit a single bridge guitar.
Anonym 12.06.2014
Don't take this as a negative review, whilst I didn't get to use the kit it would have fit the Bigsby very snug and is the same colour as the Bigsby, not that it is noticeable under the Tremolo at all.
It comes with very clear instructions, a sticker, and two types of screws
The guitar I was fitting to is an Epiphone LP Special 1 LTD.Ed. WC and I couldn't use it because it has a single bridge. You may want to check with Vibramate on their Facebook or message them through their website if you are unsure.
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension