Med våra cookies vill vi erbjuda dig den renaste shoppingupplevelsen med allt som medföljer. Detta inkluderar till exempel lämpliga erbjudanden och att komma ihåg preferenser. Om detta är okej för dig så klickar du bara på "Okej" att du accepterar då användningen av cookies för preferenser, statistik och marknadsföring (visa alla). Du kan när som helst återkalla ditt samtycke via cookieinställningarna (här).
Drilled out to mount some BNC through-connectors into a rack panel.
These blanking plates are flat on both sides - no embossing or other moulding - so you can drill them out as required to mount other connectors that aren't otherwise supported in D-format panels. Use the Neutrik MFD mounting plates for a good strong mount of this blanking plate with your choice of connector. I used for BNCs but this approach would also work for jack sockets or RCA phono for example.
Use the Neutrik ones for a pro finish where you want a genuine blank (again use the MFD).
I went for these over the Neutrik ones, and I'm glad I did. They're cheaper, made from plastic, but since they're just a blanking panel, they don't need to be anything else, and when mounted from the back, it's completely flush with the panel itself, giving a nice, clean look.