Kovax KCR400 Sel-Adhesive Sandpaper

13

Self-Adhesive Sandpaper

  • Suitable for use with HOSCO H-SB sanding blocks
  • Grit size: 400
  • Width: 64 mm
  • Length: 3.4 m
Myynnissä vuodesta Tammikuu 2021
Tuotenumero 511195
Myyntierä 1 kappaletta
9,90 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Saatavilla pian (2-5 päivässä)
Saatavilla pian (2-5 päivässä)

Tämä tuote on tilattu ja saamme lisäerän tätä tuotetta varastoon muutamassa päivässä.

Tietoa lähetyksestä
1

13 Asiakkaiden arviot

4.6 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

6 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
T
Good quality for wood, NOT for metal!!!!
TrEr 07.06.2021
In Thomann's product description of the corresponding sanding blocks this sandpaper is recommended for fret leveling. Unfortunately this sandpaper is very poor for metal frets. It clogs up and gets dull almost immediately. I also tested it for polishing frets after leveling/crowing with the same poor result. Any decent quality sandpaper from your local hardware store will probably do a better job with frets.

It works great when used on wood though and it's a perfect fit for radius sanding blocks. I've leveled several fretboards using this sandpaper with excellent results.

Recommended for wood/fingerboards. Not recommended for frets.
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
i
Fret leveling
io74 13.04.2023
Used it for leveling the frets of a brand new strat that was must have skipped the ordinary quality control for the neck. I decided not to return the guitar just because i loved the finishing and the sound of the pickups. Attached to a sanding block of the appropriate radius, the paper did its job just great.
Of course fret polishing was required after that, but that's another story.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta