Schaller BM 4L BC

57

Set of tuning pegs for 4-string electric bass

  • Design: 4 pegs, left-hand
  • Vintage style
  • Gear ratio: 1:20
  • Schaller No: 10250401
  • Finish: Black Chrome
Fås siden December 2008
Artikelnummer 221600
salgsenhed 1 stk
Colour Black
666 kr
Inkl. moms. Obs! Yderligere fragtomkostninger 60 kr
På lager indenfor 2-3 uger
På lager indenfor 2-3 uger

Denne vare forventes på lager indenfor kort tid, hvorefter den kan sendes med det samme.

Information om forsendelse
1

57 Kundebedømmelser

4.9 / 5

Du skal være logget på, for at kunne vurdere et produkt.

BemærkVi tillader kun vores kunder, at afgive en vurdering af det udstyr de har købt hos os. Vi modtager ikke anmeldelser eller vurderinger af produkter fra tredje kilde.

Efter login finder du også i kundencenter under "vurderinger af produkt" alle artikler, som du kan afgive en vurdering af.

forarbejdning

33 Anmeldelser

google translate gb
Der opstod en fejl. Prøv igen senere.
t
Precise and stable
taddeomaiden 21.10.2017
The machine heads are extremely solid and allow precise tuning and stability.
Esthetically flawless and elegant as any black hardware, the installation is easy, IF you have corresponding holes, otherwise you might have some difficulties, as I had, because the mounting rings are slightly smaller than the most common ones.
The machine heads are similar to the newest ones used on Fender basses, although they don't have the typical trapezoidal plate but a smaller one.
forarbejdning
1
0
Anmeld bedømmelse

Anmeld bedømmelse

google translate gb
Der opstod en fejl. Prøv igen senere.
r
great quality
remork 30.11.2020
used for experimental long string instrument, to put tension on +2m piano wire. did the job just fine. had to (over)tighten the screw because of higher tension than usual (and unorthodox break angle), which put too much tension on the plastic washer inside, but once installed properly they held out without further complaints. that said, if you're using them for what they were are for, instead of the abuse i put them through, i'm sure they will also satisfy :)
forarbejdning
0
0
Anmeld bedømmelse

Anmeld bedømmelse

google translate gb
Der opstod en fejl. Prøv igen senere.
P
All good
Plywoo 19.11.2021
I used these to replace the revoltingly bad tuners on my Sterling Ray 35, and they are pretty much flawless so far. For info, I had to drill new holes on the bass head but that's unavoidable, at least for black tuners.

I haven't seen any issue with these, they seem solid, keep the tune perfectly and are easy to adjust. Simple and flawless as a good hammer.
forarbejdning
0
0
Anmeld bedømmelse

Anmeld bedømmelse

google translate gb
Der opstod en fejl. Prøv igen senere.
up
Schaller nuff said.
unknown pleasure 19.11.2019
Got these on my Ray 24 as well in chrome. Got these for the PB-20 bass.
They're black chrome. Feels like powder coat way more durable then any paint.
Never had issues with schaller products and I have been using them since the 80's.
Everything is there, screws, rims the lot. I put a dab of grease on the worm for extra smoothness.
Excellent replacement for any type of P/J bass or stingray.
You can reverse these so for a Ray look no further.
forarbejdning
0
0
Anmeld bedømmelse

Anmeld bedømmelse