Med vores cookies tilbyder vi dig den nemmeste shopping oplevelse overhovedet muligt. Dette inkluderer matchende tilbud samt lagring af dine præferencer. Hvis dette er okay med dig, skal du blot klikke ”Lad os gøre det!”. Herved godkender du nemlig vores brug af cookies til at gemme dine præferencer, statistik og marketing (vis alle). Du kan til enhver tid trække dit samtykke tilbage via cookie-indstillingerne (her)
Du skal være logget på, for at kunne vurdere et produkt.
BemærkVi tillader kun vores kunder, at afgive en vurdering af det udstyr de har købt hos os. Vi modtager ikke anmeldelser eller vurderinger af produkter fra tredje kilde.
Efter login finder du også i kundencenter under "vurderinger af produkt" alle artikler, som du kan afgive en vurdering af.
Drilled out to mount some BNC through-connectors into a rack panel.
These blanking plates are flat on both sides - no embossing or other moulding - so you can drill them out as required to mount other connectors that aren't otherwise supported in D-format panels. Use the Neutrik MFD mounting plates for a good strong mount of this blanking plate with your choice of connector. I used for BNCs but this approach would also work for jack sockets or RCA phono for example.
Use the Neutrik ones for a pro finish where you want a genuine blank (again use the MFD).
I went for these over the Neutrik ones, and I'm glad I did. They're cheaper, made from plastic, but since they're just a blanking panel, they don't need to be anything else, and when mounted from the back, it's completely flush with the panel itself, giving a nice, clean look.
The covers are clean, no branding, no text.
Makes the blanking plate look clean especially when rear mounted.
It would be nice if screws were included.